Hey guys,
I had a project for work where I had to connect 20 stripe of RGBW LED strips together last week (5 pins, 24V)
I was just wondering how they should have been connected together. I had CAT5 cable soldered to the pins to extend them out of view and then 5×20 strands loose below which I ended up making a spaghetti mix of cable soldering all together.
This was the worst possible way of doing it in my mind but running out of time it was all that I could do before the project had to leave.
As a learning experience how should it have been done instead?
Over the past 50 years, Nichia has demonstrated its commitment to improving the overall performance…
To fund the acquisition and ongoing operation of the production facility, BluGlass has secured A$3.4…
New CAS 140D IR spectroradiometer with improved optical and electronic components offer the user higher…
SSC boasts world's only LED and LD technology for vehicles using all wavelengths of light…
E-cars do not have a classic radiator grille, so the front of the vehicle…
“We welcome the further alignment of ANSI C137.4-2021 and D4i, which is expected to lead…